- Minimum Order Quantity
- 250 Piece
- 220 per kg INR
Being a prominent firm of experienced experts and utilizing advance technology, we are affianced in providing Foundry Coatings. Known for their chemical and water resistance attributes and remarkable binding strength, these foundry coatings are utilized for non ferrous foundry applications. We formulate these coatings utilizing high-grade ingredients that are sourced from the reliable experts of the market. Moreover, the foundry coatings offered by us are packed utilizing air-tight packaging material in order to protect these coatings from moisture.
CRAFTCOTE - CEN is recommended for all C.I. Casting. It can be applied by dipping / brushing application. Thick coating to be applied to get good insulating effect. The insulating property of coating reduces the solidification rate of metal. Recommended for reducing the chilling / hardening of metal at thin section wall casting.
After applying coating air dry it for 10 to 20 minutes and then dry in oven at 150°C to
160°C for min. 20 minutes or by torching
Centrifugal dicasting coating
Clean the die and blow air to remove foreign material and dust. Stir the coating and dilute it by ratio 100:5 to 100:10 ( i.e. product : water). Apply by spraying on hot die (at die temperature 150° C to 180° C) and coat up to 1mm thickness. If thickness is not achieved in one spray, apply again. Keep the die rotating while spraying CRAFTCOTE - CEN (M), so as to get uniform coating thickness. Now pour the casting.
After removing casting, again clean the die surface and apply coating by same procedure.
Special Inoculation Coating
Apply CRAFTCTOE - SN as it is on sand mould core by brushing. If the permeability of sand is more then we recommend to have a precoat with zircon or other mixed refractory water based coating. Dry the coating and then apply CRAFTCOTE- SN. Dry it oven at 120ÃƒÆ’Ã‚¯Ãƒ¢Ã¢â€š¬Ã…¡Ãƒâ€šÃ‚° C for 1 hr. Ensuring removal of moisture from the coating. Mould/ Core is then ready for pouring. Do not apply and other coating on CRAFTCOTE- SN.
SPECIAL CHILLING COAT
1) CRAFTCOTE - TE is to be applied as it is by brushing or swabbing after uniform
mixing. If required coating can be further diluted with water in case thinner coating
consistency is needed.
2) Mould or core should be thoroughly dried before pouring the metal. (Do not heavily
torchh the coating) .
3) Whenever double coating is required take care that the previous coat is thoroughly
|1) CRAFTCOTE - TES is to be applied as it is by brushing or swabbing after uniform mixing. |
2) Mould or core should be thoroughly dried before pouring the metal. (Do not heavily torch the coating).
3) Whenever double coating is required take care that the previous coat is thoroughly air dried.
For economical practice, give first coat of zircon base coating on the portion when CRAFTCOTE - TES is to be used.
- Supply Ability
- As per REquirement Per Day
- Delivery Time
- 2-3 Days